403.844.2141 info@tomco.ca

TOMCO INDUSTRIAL LTD.

HYDROTEST EQUIPMENT & ISOLATION PLUGS

Curtiss-Wright is a leading provider of high performance valves and related products for safe, reliable and efficient processing to the defense, energy and general industrial markets.

GRIPTIGHT® HIGH PRESSURE TEST PLUGS

Test Open End Pipes, Pipelines, Tubes and Pressure Vessels

+ I.D. Sealing Version
+ Pressures to 14,000 psi (960 Bar)
+ Sizes from .93″ to 8.53″ (23.6mm – 216.7mm) 
+ Larger Sizes through 42″ (1066.8 mm) Available

GRIPTIGHT MAX® TEST PLUG

GripTight® MAX Test Plugs are highly effective in applications such as down hole / well-head piping, high pressure steam systems and in the replacement of older piping with newer high alloy hardened pipe materials used in refineries and chemical plants.

+ Test pressures to 15000 Psig (1034 BarG)
+ New hardened shaft increases durability, plug life and reduces wear

GRIPTIGHT® ELBOW TEST PLUG

GripTight Elbow Test Plugs use patented GripTight MAX grippers to provide a safe and effective testing environment by using test pressure to grip more securely against the pipe. Superior solution for testing pipe spools and piping systems for elbow applications!

+ Test Pressure: 3,350 PsiG (231 BarG) – higher pressures available
+ Size Range: 2” – 24” (DN50 – DN600) – larger sizes available

HIGH LIFT FLANGE WELD TEST PLUG

High Lift Flange/Weld Test Plug lets you monitor upstream conditions, isolate and purge the weld area, perform the weld, and hydro test weld joint to ANSI B16.5 requirements using only one tool.

+ Operating Pressures to ANSI B16.5 Requirements
+ Pipe sizes from 3/4″ to 36″
+ Flange Classes 150-600lb.

Snap It® Sr and Snap It® Jr plugs are rated up to 7,000 PSID, and 1,000 PSID respectively. Snap It tube plugs offer increased safety when plugging heat exchanger, boiler & condenser tubes by reducing chances of blowout and by not requiring welding for installation. 

Snap It® Sr – HIGH PRESSURE TEST PLUGS

The Snap It Sr installs in less than 60 seconds, and you can skip the welding required for tube plugs in high-pressure applications. Snap It tube plugs install in just minutes with a hydraulic ram and create a seal strong enough to hold up to 7,000 PSID.

Snap It® Jr – HIGH PRESSURE TEST PLUGS

Now you can install tube plugs without welding and in 80% less time, avoid tube sheet damage completely, and Snap It Jr is rated @ 1,000 PSID!